Introduction to Drafting and Autodesk Inventor

November 15, 2021 | Updated: November 20, 2021
Author: Wally Baumback, Vancouver Community College

This book contains self-paced learning modules that were written as a tool to guide and teach you to master Inventor. No two students learn at the same pace, therefore, the modules were written as competency-based bite-size pieces to allow you to work at your own pace. They can be used in correspondence courses, online courses, instructor-lead classes or by individuals teaching themselves to use Inventor in their own home or office.

Subject Areas
Engineering, Engineering - General

Original source
opentextbc.ca

Adoptions:
Tell us you are using this Open Textbook

Adaptations:
Support for adapting an open textbook

Need help?
Visit our help page

Accessibility:
Textbooks flagged as accessible meet the criteria noted on the Accessibility Checklist

textbook cover image
“City Light employee at drafting table, 1974” (https://flic.kr/p/2j8ZsNP) from the Seattle Municipal Archives (https://www.flickr.com/photos/seattlemunicipalarchives/) is licensed under a CC BY 2.0 licence (https://creativecommons.org/licenses/by/2.0/).

Creative Commons License
Introduction to Drafting and Autodesk Inventor by Wally Baumback, Vancouver Community College is licensed under a Creative Commons Attribution 4.0 International License, except where otherwise noted.

Similar Textbooks


There are currently no reviews for this book.

Be the first to request to review this textbook